Pines #1 1/4& #2 Tube & Pipe Benders
Stationary Arm Assembly


Note: Click on large image when it appears for fully expanded view.

KEY
H.I.T. PART NO.
REPLACES
PART NO.
NO.
REQ'D

DESCRIPTION
1 (LH)
30010-06700 112-10-067-00
1
Stationary Arm Weldment – LH (CCW)
1 (RH)
30010-06701 112-10-067-01
1
Stationary Arm Weldment – RH (CW)
2
30010-29500 112-10-295-00
1
Gib, Slide
3
30010-43000 112-10-430-00
4
Toggle Link (w/ 2 Bushing 30010-43000-BB)
3-A
30010-43000-BB (if sold separately)
8
Bushing Only, Toggle Link (ID Sizing Req’d)
4
30010-50400 112-10-504-00
1
Pin – Upper Rear (Includes $3 & $4)
5
30010-50401 112-10-504-01
1
Pin – Clevis (Includes $2)
6
30010-50600 112-10-506-00
1
Pin – Rod End (Includes $3 & $4)
7
30010-51000 112-10-510-00
1
Pin – Slide (Includes $3 & $4)
8
30010-65200 112-10-652-00
1
Rod End – Clamp Cylinder
9
30010-72500 112-10-725-00
1
Slide – Ampco Bronze, LH (used on LH & RH)
10
30010-80501 112-10-805-01
1
Clamp Bar – Left Side
11
30010-80502 112-10-805-02
1
Clamp Bar – Right Side
12
30010-80700 112-10-807-00
2
Wear Strip - Slide
13
30010-15501 112-10-155-01
1
Wear Strip – Slide Hold Down
14 (LH)
30010-15503 112-10-155-03
1
Slide Hold Down Block – Stationary Arm (LH)
14 (RH)
30052-15504 112-10-155-04
1
Slide Hold Down Block – Stationary Arm (RH)
15
30052-15500 112-52-155-00
1
Slide Back-up Block – 1” (Not Shown)
16
30052-15501 112-52-155-01
1
Slide Back-up Block – 2” (Not Shown)
17
30052-15502 112-52-155-02
1
Slide Back-up Block – 3” (Not Shown)
18
30052-15503 112-52-155-03
1
Slide Back-up Block – 4” (Not Shown)
19
30052-15504 112-52-155-04
1
Slide Back-up Block – 5” (Not Shown)
$1
30024-24200 112-24-242-00
1
Hydraulic Cylinder (Less fittings)
$2 - $21
(Call for info)  
N/A
Standard Purchase Components & Fasteners



Web Site: www.bendersupply.com
© 2008 Haller International Technologies, Inc.


Haller International Technologies, Inc.

Tel: 313-821-0809
Fax: 313-821-0840
E-mail us: info@bendersupply.com

609 St. Jean
Detroit, MI 48214 USA